GENTLE TT Mini T-Type Quick Coupler｜Compact Three-Way Manifold

• Compact Profile, Full Range of Sizes (4/6 mm): ~40% smaller and ~20% slimmer OD for dense layouts in control cabinets, behind panels, and jigs/fixtures.
• Inline T Layout: Two push-in ports stay inline while the threaded branch is perpendicular—clear routing and compact maintenance zones.
• Single Inlet, Dual Outlets: Near-point teeing shortens runs, reduces adapters and ΔP, and lowers leak paths.
• Push-to-Connect, Quick Service: Insert fully to the stop to lock; press the release ring to disconnect, minimizing downtime.
• Hex Wrenching + Pre-Sealed RC Threads: Factory-applied sealant enables tape-free installation in most cases; wrench flats above the thread aid precise seating and orientation.
• Airtight & Vibration-Resistant: O-ring + metal collet ensure reliability within 0–0.9 MPa, 5–60 °C; black or grey-white (-GW) colorways support line ID.
• Applications: Valve-island/cylinder branching, in-cabinet distribution, dual feeds at EOAT, compact manifold splits, behind-panel teeing, and quick trunk branching.

Q1: How does TT (MINI) differ from UT (MINI)?
A: TT (MINI) uses two push-in + one threaded port for direct mating to valves/bodies; UT (MINI) has three push-in ports for thread-free tube splits.

Q2: Why use the inline main + perpendicular branch?
A: It keeps the main run straight and the branch clear, shortening tubing, cutting pressure loss, and simplifying maintenance.

Q3: What tubing and sizes are supported?
A: PU and nylon (PA) in 4 mm and 6 mm OD. Cut square, deburr, clean/dry, then push fully to the stop for airtight seating.

Q4: Do RC-threaded models require PTFE tape?
A: Typically no—RC threads are factory pre-sealed. After repeated servicing, reapply sealant or add a light PTFE wrap if needed.

Q5: Recommended installation sequence?
A: Wrench and orient the threaded port → cut square, deburr, clean/dry the tube → push fully to the stop → pull-check → pressure-hold/leak-test.

Q6: Is it reusable?
A: Yes. Before reinsertion, re-cut a fresh section and keep the tube end clean and square to preserve sealing and retention.

Q7: Operating range & media guidance?
A: 0–0.9 MPa, 5–60 °C, with clean, dry compressed air; filtration and water removal are recommended for longevity.