GENTLE UEF TAC Nut-Clamp Fitting｜M5 Dual-Gasket Seal · Single Side Por

• Single Side M5 Female Port: A dedicated point for gauging, bleeding, air shots, or sampling—fewer leak paths than multi-port blocks.
• Dual Rubber Washers (Face-Seal): One under the slotted plug and one under the M5 mounting stud for airtight, vibration-resistant sealing.
• Slotted Plug: Quick open/close for maintenance venting or temporary test connections.
• M5 Stud Mounting: Panel/bulkhead face-seal installation minimizes leak paths and provides positive seating.
• Compact Nickel-Plated Brass Body: Corrosion-resistant and reusable; ideal for panel corners, module edges, and cramped spots.
• Applications: Pre-sealed test/bleed port on valve islands or panels, temporary measurement/charge points on fixtures, micro take-off at robot EOAT, wall-side single connection to reduce adapters and tubing length.

Q1: How many ports does UEF have?
A: One side M5 female port. The top is a slotted plug (with rubber washer); the bottom is an M5 mounting stud (with rubber washer). It’s not a multi-port fitting.

Q2: Where are the two rubber washers?
A: One sits under the plug, the other under the mounting stud—both are face-seal points.

Q3: Is it reusable?
A: Yes. During service, inspect the rubber washers and threads; replace worn parts as needed.

Q4: Can I connect a hose directly?
A: Use a male M5 push-in fitting (or compatible adapter) in the side port to connect tubing.

Q5: What media/conditions are recommended?
A: Clean, filtered compressed air. For vacuum, special media, or high-vibration use, validate material compatibility and sealing in your setup first.

Q6: Any installation notes?
A: Both the plug and stud are face-seal interfaces. Tighten to seat and seal—avoid over-torque that could damage the rubber washer. Ensure the mating face is clean before attaching instruments or adapters.