FAQ
Q1: How do these fiber optic units detect a part?
A: The emitter and receiver face each other. The amplifier sends light through the transmitting fiber and monitors light returning through the receiving fiber. A part crossing the beam changes the amount of light received.
Q2: How do the GLT505J, GLT510J, and GLT520J differ?
A: Cable length is the main difference. The GLT505J is 0.5 m, the GLT510J is 1 m, and the GLT520J is 2 m. All three have the same mounting threads, tip temperature range, and F80R sensing ranges.
Q3: Which parts carry the 200°C rating?
A: The sensing tips are rated for ambient temperatures from −60 to +200°C. The PFA tubing is rated to 200°C. Install the amplifier within its own ambient temperature range.
Q4: Which F80R mode should I use for a 500 mm sensing gap?
A: Use long-distance mode, which is rated to 610 mm. High-speed mode is rated to 340 mm, so it cannot cover a 500 mm gap.
Q5: What sensing gap can I use with an F70R, F70AR, or F71R?
A: The F70R and F70AR are each rated for 340 mm with these units. The F71R is rated for 195 mm. When replacing a fiber unit, check the installed amplifier model and measure the gap between the heads.
Q6: How do I mount the M4 sensing heads?
A: Use a mount that accepts M4 × 0.7 threads and align the emitter with the receiver. Limit tightening torque on the threads to 0.8 N·m.
Q7: How do I select a cable length if the amplifier is already installed?
A: Measure each head’s cable route to the amplifier, including bends. Choose 0.5, 1, or 2 m to cover the longer route. Keep the fittings at both ends intact during installation.
Q8: How tightly can I bend the 2.8 mm cable?
A: Allow a bend radius of at least 25 mm. Leave room for a gradual curve around fixture corners and avoid a sharp bend where the cable exits a fitting.
Q9: Can these units detect a part as small as 0.015 mm in diameter?
A: All three have a min. detectable object diameter of 0.015 mm. This rating excludes the F71R and F2R. If the part blocks only a portion of the beam, test it at the intended gap and check the change in received light.
Q10: What if I only have mounting access on one side of the part?
A: These through-beam units need an emitter and a receiver on opposite sides of the sensing path. For one-sided access, consider the heat-resistant GLX505J, GLX510J, or GLX520J reflective unit. Select it for the target surface and working distance.