FAQ
Q1: Can I use these units if I can mount a head on only one side of the target?
A: Yes. The GXH505J, GXH510J, and GXH520J transmit and receive light through the same head. The fiber amplifier detects a change in the light reflected by the target.
Q2: Which model should I choose for my cable run?
A: Measure the route from the sensing head to the amplifier. Choose the GXH505J for 0.5 m, the GXH510J for 1 m, or the GXH520J for 2 m. All three have a dedicated connector at the amplifier end.
Q3: Does the 350°C rating also apply to the fiber amplifier?
A: The −60 to +350 °C rating applies to the fiber unit. Choose an amplifier location within that amplifier’s own temperature range. For example, a single F85RN is rated for −25 to +55 °C.
Q4: What thread pitch and tightening torque should I use?
A: All three heads have an M4 × 0.7 thread with a 0.7 mm pitch. Tighten to 0.8 N·m max. The sensing face is 23 mm from the start of the spiral tubing.
Q5: How far do the 0.5 m and 2 m models reach with an F80R?
A: The 0.5 m GXH505J reaches 135 mm in long-distance mode and 75 mm in high-speed mode. The 2 m GXH520J reaches 130 mm in long-distance mode and 70 mm in high-speed mode.
Q6: If I keep my F71R and switch to a 2 m cable, will I need to move the head?
A: The GXH505J and GXH510J each reach 45 mm with the F71R. The 2 m GXH520J reaches 40 mm. If your current head is mounted 45 mm from the target, move it closer when fitting the GXH520J.
Q7: Which distance should I use when setting up an XF12R-A?
A: All three units reach 130 mm in long-distance mode and 45 mm in H-SP mode. If the amplifier will run in H-SP mode, use 45 mm when planning the head-to-target spacing.
Q8: What does R25 mean for cable routing?
A: R25 specifies a bend radius of at least 25 mm. All three cables have a 2.8 mm outer diameter and require the same bend radius, including the longer versions.
Q9: What do the 1.1 mm and 0.015 mm diameters refer to?
A: The entire glass fiber bundle is 1.1 mm in diameter and is divided into two sections. The 0.015 mm value is the min. detectable target diameter. This target rating excludes the F71R.
Q10: What target should I use as a reference with the F70R?
A: The standard target is 100 × 100 mm white drawing paper. If your target differs in size or surface finish, check the reflected signal with your actual part at the intended working distance.